30 The Installation Menu
*1: You cannot adjust anything other than th e targeted adjustment zones in “Zone B lack Level Adj.”
*2: When selecting the correction zo ne of “Zone Black Level Adj.,” the targeted correction zone
flashes twice.
*3: When “Edge Blending” is set to “On ,” “Screen Fitting” (HV Keystone/Warping) is not
displayed.
*4: Depending on the position adjusted with the lens shift feature, the aspect ratio of the image may
change from the original or projected image may be distorted with Keystone adju stment.
*5: Since the HV Keystone/Warping adjustment is an electronic correction, the image may
deteriorate.
*6: Select “Link to Image Flip” on ly for horizontal installation. Be sure to select “Fro nt Up” or
“Front Down” for vertical installation, according to the installation dire ction of the projector.
(Refer to the figures.)
*7: In the case of a portrait installation , pay attention not to block the ventilation holes (exhaust/
intake).
*8: Do not use the projector at an altitude o f 2,700 m or higher.
*9: Depending on the adjustment value of “Panel Alignment,” the color and resolution may be
changed.
*10:The brightness and color of the projected image may not match completely, even after you adjust
“Brightness” and “Color.”
*11:If the Screen Aspect is set to 16:10 and input signal is 16:10 or 16:9, the image will be projected
at the correct aspect. This function is not available when displaying two pictures.
Color Matching*10 Adjust/Reset: For correcting the brightness and color of the whole
projected image manually from the signal level in six steps.
Notes
Setting items Description