Recording
Now you are ready for underwater recording.
When you dive with the camcorder, dive slowly, paying attention to the surrounding environment. Be careful not to strike the marine pack against Rocks or Reef, etc.
POWER switch
AUTO FOCUS ON/OFF button
ZOOM button
REC lamp |
| |
(red) | PHOTO button | |
LEAK lamp | ||
START/STOP | ||
(yellow) | ||
| button |
GB
1Set the POWER switch to ON.
The camcorder turns on and a picture appears on the LCD monitor.
2Press START/STOP button to start recording. The REC lamp (red) lights up during recording.
To stop recording, press START/STOP button again.
To zoom
Press ZOOM button.
Press T for telephoto (subject appears closer) and W for
Recording a still image
You can record a still image on a tape or “Memory Stick” by pressing PHOTO button. (Some models, however, can only record onto a tape, even if a “Memory Stick” can be inserted.) Note that pressing PHOTO button lightly does not allow you to check the recorded image. For more details, refer to the operating instructions supplied with your camcorder.
To keep a subject in focus
Press AUTO FOCUS ON/OFF button to set it to OFF. You can still keep the subject in focus even if fish swim between the camcorder and the subject. Press AUTO FOCUS ON/OFF button again to set the camcorder to auto focus mode.
Note
Do not cover the control emitter or detector with your finger as the remote control signal for operations is transmitted from the grip to the marine pack.
continued