2Do either a) or b) to create a program: “Program In” appears in the display for a few seconds at the beginning of either of the following procedures.

a)When using the controls on the deck

Turn AMS until the track number you want flashes in the display.

Until you press the AMS control to enter the next track, you can continue turning the AMS to change the track selection. Furthermore, until you press ·to start Program Play, you can change any other track in the program (see “Changing the track order” on this page).

If you enter the wrong track number

Press 0or )until the wrong track number flashes, then turn AMS to enter the correct track number.

b)When using the remote

Press the number buttons to enter the tracks you want to program in the order you want. To program a track with a number over 10, use the >10 button (see page 12).

If you enter the wrong track number

Press 0or )until the wrong track number flashes, then enter the correct track number with the number buttons.

3Press AMS, then repeat Step 2 to enter other tracks.

Each time you enter a track, the total program time is added up and appears in the display.

4Press ·to start Program Play.

To stop Program Play

Press p.

To cancel Program Play

While the deck is stopped, press PLAY MODE repeatedly until “PROGRAM” disappears.

zThe program remains even after Program Play ends

When you press ·, you can play the same program again.

Notes

•The display shows “- -m - -s” instead of the total playing time when the total playing time of the program exceeds 199 minutes.

•“ProgramFull” appears when you program over 25 tracks. Erase the unnecessary tracks to enter other tracks.

•The program is erased when you turn off the deck or disconnect the AC power cord.

Playing CDs and MDs

Changing the track order

You can change the order of the tracks in your program before you start playing.

To

Do the following:

Erase a track

Press 0/)repeatedly until the

 

number of the unwanted track

 

flashes, then press CLEAR.

 

 

Erase all tracks

Press CLEAR repeatedly until all the

 

track numbers disappear.

 

 

Add a track at the

Press 0repeatedly until the cursor

beginning of the

flashes before the first track number,

program

then do Step 2 above.

 

 

Add a track in the

Press 0/)repeatedly until the

middle of the program

track number which will precede the

 

new track flashes. Press AMS to

 

display flashing cursor, then do Step 2

 

above.

 

 

Add a track to the end

Press )repeatedly until the cursor

of the program

flashes after the last track number,

 

then do Step 2 above.

 

 

Replace a track

Press 0/)repeatedly until the

 

number of the track to be changed

 

flashes, then do Step 2 above.

 

 

zYou can check the playing time and title of a track before you add or erase it

Press TIME or TIME/CHAR while the number of the track is flashing in the display. The playing time and the title of the track (if the track is labeled) will appear.

15