Recording on MDs

Set “T.Mark” in Setup Menu to “LSyn” or “Off” as follows:

1Press MENU/NO twice to display “Setup Menu” while the deck is stopped.

2Turn AMS to select “T.Mark LSyn,” then press AMS.

3Turn AMS to select “T.Mark LSyn” or “T.Mark Off,” then press AMS.

If you select “T.Mark LSyn,” “L.SYNC” lights up in the display.

4Press MENU/NO.

Note

If you turn off the deck or disconnect the AC power cord, the deck will recall the last setting of the track marking function (“LSyn” or “Off”) the next time you turn on the deck.

Recording the Current CD Track (REC-IT Function)

You can record specific tracks on a CD while listening to them. This function allows you to put only the tracks you like onto the MD.

When using the remote, set SELECT to CD.

·REC-IT

? 1/u

§

 

§

 

 

 

0 )

­ ±

­ ± 0 )

r

· P

p

· P

p

1Press ·on the CD player section.

Make sure that the MD deck section is stopped.

2Press REC-IT when you hear a track you want to record.

Play returns to the start of the track and recording starts. The recording stops at the end of the track, but CD playback continues from the next track.

To stop recording

Press pon the CD player section.

Notes

•You cannot record over existing material during REC-IT Recording. The deck automatically starts recording from the end of the existing material.

•Make sure that the remaining recordable time on the MD is longer than the playing time of the CD track.

•The recording level specified in the Setup Menu (page 20) is not applied during REC-IT Recording. The initial reference level (0.0 dB) is used instead.

While “TOC Writing” is flashing

Do not move the deck or pull out the AC power cord to ensure the complete recording. The deck is currently updating the Table Of Contents (TOC) of the MD.

22