While recording

Symptom

Cause/Remedy

 

 

The remaining

• This is a system limitation. 2.0MB is the capacity of the reserve

recording time appears

domain.

as “–0:00:00” and

 

recording cannot be

 

done, even though

 

2.0MB of free space is

 

displayed.

 

 

 

The recorder always

• The group recording (“Group REC”) is set to “GroupREC On”.

creates a new group

(You cannot overwrite tracks.)

when recording.

, Set the group recording setting to “GroupREC Off” (page 40).

 

 

The first few seconds of

• If you start recording while the disc indication is rotating, data will

a track cannot be

not be recorded to the first few seconds of the first track.

recorded.

, Wait until the disc indication stops rotating before you start

 

recording.

 

 

Recording cannot be

• Audio sources may not be securely connected.

done correctly.

, Disconnect the audio sources once and connect them again

 

(pages 20 and 36).

 

• There is no digital signal from the portable CD player.

 

, When recording digitally from a portable CD player, use the

 

AC power adaptor and disable the anti-skip function (such as

 

ESP) on the CD player (page 24).

 

• The analog recording was made using a connecting cord with an

 

attenuator.

 

, Use a connecting cord without an attenuator.

 

• Recording level is too small to record (when adjusting the

 

recording level manually).

 

, Pause the recorder and adjust the recording level (page 38).

 

• The recorder is connected to the computer.

 

, Disconnect the recorder from the computer when recording.

 

• The power sources was disconnected or a power outage occurred

 

during recording.

 

, The recording result is not recorded on the disc. Make

 

recording again.

 

• The premastered disc is inserted.

 

, Replace to the recordable disc.

 

• Recording may not be done if the remaining recordable time on the

 

disc is 48 seconds or less (“DISC FULL” appears).

 

, Replace the disc.

 

 

Stereo sound is heard in

• This is normal. During digital recording, the sound will be stereo

the headphones/

in the headphones/earphones, even though the recorded sound is

earphones while

monaural.

recording in monaural.

 

 

 

Momentary noise is

• Due to the special digital audio compression technology used in

heard when recording.

LP4 stereo mode, momentary noise may occur on very rare

 

occasions with certain sound sources.

 

, Record in SP or LP2 mode.

 

 

81