3Press Pagain to start recording.

4Start the sound source.

Tips

• The recorder switches back to stereo recording when you press pto stop recording.

•If you record in monaural from a stereo source using a digital cable, only the left channel sound of the source will be recorded.

•The MDs recorded in monaural can be played back only with an MD player/ recorder that has the monaural playing function.

Adjusting the recording level (Manual recording)

See the illustration in the Japanese text (page15).

When you record with a microphone or analog input, the sound level is adjusted automatically. If necessary, you can set the level manually. You can operate in the same way on the station as on the recorder.

1While holding down P, hold the 録音 (record) switch to the right for more than 2 seconds.

"ManualREC" appears, and the recorder enters record pause mode. To return to automatic control, while the recorder is in record pause mode, hold the 録音(record) switch to the right for more than 2 seconds.

2Play the source.

3While observing the level meter in the display, adjust the recording level by pressing +(+) or =(–).

Set the level to arround 12 (-12dB) on the station or until 4 lines appear on the recorder.

4Press Pagain to start recording.

Tips

•The recorder switches back to automatic control when you press pto stop recording.

•The recording level should be adjusted while the recorder is in standby mode. You cannnot adjust it while recording.

•Select the input level with the マイク感度 (Mic sensibility) switch if you record sound from マイク（プラグインパワー）(Mic) jack.

Setting the clock to stamp the recorded time

See the illustrations in the Japanese text (page17).

To stamp the date and time on the MD when you record, you need to set the clock. The recorder and the station each have a clock. The time of the recorder is copied to the clock of the station when you attach the recorder to the station.

1Press 時計合わせ (clock set) button at the rear of the station with a pointed object. The digits of the year flash.

2Enter the current year by pressing = or +.

To change the digits rapidly, keep pressing =or +.

3Press (or CURSOR→.

The digit of the month flashes.

4Repeat steps 2 and 3 to enter the current month, date, hour, and minute. After you press (to set the minutes, the clock starts operating.

If you make a mistake while setting the clock

Press pbutton and repeat the steps above. Press (tto locate necessary digits to be changed.

To display the time in the 24-hour system

press 表示 (display) button while setting

 

clock

Operating

the clock. To change the clock to the 12-

 

hour system, press 表示 (display) again.

 

Charging the built-in battery for the

Instructions

power sources. The recorder will

After setting the clock, leave the recorder

 

attached to the station for about 2 hours to

 

charge the built-in battery for the clock. Once

 

charged, the built-in battery will last for about

 

a month without being connected to any of the

 

automatically charge the built-in battery while

 

operating on the station, a rechargeable

 

battery or dry batteries.

 

57