[Test Mode $Display Check Mode%]
Press the > *1) or [VOL +] *3) key
[Manual Mode]
Press the x *3) key
[Servo Mode]
[Audio Mode]
[Power Mode]
[OP Alignment Mode]
Press the . *3) or [VOL
[Overall Adjustment Mode]
Press the x *3) key
Press the N *1) or [REC] *1) or N > *2) key
Press the x *3) key
[Sound Skip Check Result Display Mode]
press the [DISPLAY] *2) or MENU . *1) key
[Self-Diagnosis
Press the x *3) key
Press the [T MARK] *3) or [DISPLAY] *2) key on the remote commander for several seconds.
[Key Check Mode]
Quit the key check or open the upper panel
Note: *1) on the set
*2) on the remote commander
*3) on the set or remote commander
Mode to adjust or check the operation of the set by function. Normally, the adjustment in this mode is not executed.
• Transition method in Manual Mode
1.Setting the test mode. (See page 13)
2.Press the > or [VOL +] key activates the manual mode where the LCD display as shown below.
LCD display
000M a n u a l
3.The optical
4.Each test item is assigned with a
|
|
|
| [VOL +] key:100th place of mode number | ||
[Major item switching] |
| increase. | ||||
|
|
|
| [VOL | ||
|
| key |
| x key |
| decrease. |
| N |
| ||||
|
|
|
| |||
|
|
|
| [VOL +] key:10th place of mode number | ||
[Medium | item switching] |
| increase. | |||
|
|
|
| [VOL | ||
|
| key |
| x key |
| decrease. |
| N |
| ||||
|
|
|
| |||
|
|
|
|
|
| key: Unit place of mode number |
[Minor item | switching] | N | ||||
|
|
|
|
|
| increase. |
[Adjusted value variation]
[VOL +] key:Increases the adjusted value
[VOL
[Adjusted value write]
X key: When adjusted value is changed:
Adjusted value is written. When adjusted value is not changed:
That item is adjusted automatically.
