Symptom

Cause/Remedy

 

 

A new group cannot

• This is due to the MiniDisc system limitations (in MD mode only).

be created.

Group information has been written to the area where the disc name is

 

stored. The disc name and track names are recorded in the same area,

 

which can store a maximum of approximately 1,700 characters. If the

 

total number exceeds this amount, it is impossible to make group

 

settings.

 

 

While the recorder is connected to the computer

Symptom

Cause/Remedy

 

 

 

 

 

The recorder is not

• The dedicated USB cable is not firmly connected.

recognized by the

, Connect the dedicated USB cable firmly to the recorder and the

computer.

computer.

 

 

 

 

• A USB hub is used.

 

 

 

 

, Connect the dedicated USB cable directly to the USB port of the

 

 

 

 

computer.

 

 

 

 

• Network communication has failed.

 

 

 

 

, Disconnect the dedicated USB cable, wait at least 2 seconds, and

 

 

 

 

then reconnect it. If the recorder is still not recognized, disconnect

 

 

 

 

the dedicated USB cable, restart the computer, and then connect

 

 

 

 

the dedicated USB cable again.

 

 

 

 

When using Windows 2000 Professional, you turned on or restarted the

 

 

 

 

computer while the dedicated USB cable was connected, and then

 

 

 

 

disconnected it afterwards.

 

 

 

 

, Disconnect the dedicated USB cable, restart the computer, and

 

 

 

 

then reconnect the dedicated USB cable. This problem may be

 

 

 

 

resolved by updating your Windows operating system so that it

 

 

 

 

contains all the latest features.

 

 

 

 

 

Charging by USB bus

• The battery compartment lid is not firmly closed.

power cannot be done

, Reinsert the rechargeable battery and close the battery

(

 

 

flashes in the

compartment lid firmly.

 

 

 

 

 

 

• The temperature of the battery-charging location is too low or too

display).

 

 

 

 

high.

 

 

 

 

, Charge the rechargeable battery within a temperature range of

 

 

 

 

+5°C (+41°F) to +35°C (+95°F).

 

 

 

 

 

The rechargeable

• The rechargeable battery is charged through USB bus power.

battery cannot be

, USB bus power only charges temporary and cannot charge the

charged sufficiently

rechargeable battery sufficiently. Disconnect the recorder from the

through USB bus

computer and charge the rechargeable battery using the AC power

power.

adaptor.

 

 

 

 

 

Even though the

• A USB hub is used.

recorder is recognized

, Connect the dedicated USB cable directly to the USB port of the

by the computer, it

computer.

does not operate

• You are using the recorder at a place with vibration.

normally.

, Use the recorder at a place with no vibration.

 

 

 

 

 

76