INSTALLATION
3 - 2. Connecting the Power
Connect the appropriate cable to the power cable of the camera. Referring to the specified label of the camera.
(Be sure to match the correct polarity in case of 12V DC)
Insert the cable into the shrinkable tube A which shall be around 
10mm and tube B which shall be around 
3mm.
Power Cable
Shrinkable Tube A Shrinkable Tube B | Power Cable |
|
Heat the shrinkable tube B after connecting each wire. Be sure to match the correct polarity in case of 12V DC.
RED(12VDC+) OR 24VAC(~)
GREEN(COMMON GND)
SHRINKABLE TUBE
HEATING
5mm over
Shrinkable Tube A Shrinkable Tube B
After heating the three shrinkable tube B, as shown on the above, put the shrinkable tube A as the drawing above. The tube should cover the edge of the connection parts at least over 5mm and shrink it finally with heat. Apply a silicon sealant to each ends of the shrinkable tube and shrink it finally with heat.
SILICON SEALANT
Shrinkable Tube A Shrinkable Tube B
