DECK B (the
The unit does not operate or operates poorly.
•The
The player does not start playing.
•Place the
•Moisture has formed inside the unit. Take the disc out and leave the unit in a warm place for several hours until the moisture evaporates (page 4).
•Press POWER to turn the unit on.
•Replace the
The player does not start recording.
•The
•Make connections properly to the sound source (page 6).
•The sound source is not connected to the selected input connector. Select the correct input using the INPUT button (page 26).
•The recording level is set too low. Adjust the recording level properly (page 27).
•There has been a power failure or the AC power cord has been disconnected during recording. Data recorded to that point may be lost.
The sound has a lot of static.
Strong magnetism from a television or a similar device is interfering with operations. Move the unit away from any sources of strong magnetism.
Other
No sound is output.
•Make the connections properly (page 6).
•Operate the amplifier properly.
•When using the headphones, turn PHONE LEVEL to turn up the output level.
The remote does not operate the unit.
•Make sure that there are no obstacles between the unit and the remote.
•Point the remote at the remote sensor on the unit.
•Replace the batteries in the remote.
When you turn on the unit, you will hear some mechanical noise from the unit. This is not a malfunction.
After you have attempted the prescribed corrective actions
If the unit still does not operate properly, or if other problems not described above occur, turn off the unit, unplug it from the power outlet for a few minutes, then reinsert the plug into the power outlet.
Should any problem persist even after reinserting the power plug, consult your nearest Sony dealer.
Information Additional
39