7 Set the command mode for the remote so it matches the command mode for the recorder you set above.
Follow the steps below to set the command mode on the remote.
AHold down ENTER.
BWhile holding down ENTER, enter the command mode code number using the number buttons.
Command Mode | Code number |
|
|
DVD1 | number button 1 |
|
|
DVD2 | number button 2 |
|
|
DVD3 | number button 3 |
CHold down both the number buttons and ENTER at the same time for more than three seconds.
To return to the previous display
Press O RETURN.
To check the command mode for the recorder
Press x (stop) on the recorder when the recorder is turned off. The command mode for the recorder appears in the front panel display.
If the command mode for the recorder has not been changed, set the command mode for the remote to the default setting of DVD3. If the command mode for the remote is changed to DVD1 or DVD2, you will be unable to operate this recorder.
Follow the steps below to make the minimum number of basic adjustments for using the recorder.
Settings are made in the following order.
OSD Language Setup
m
Cable Box/Sat. Control Setup
m
Clock Setup
m
TV Type Setup
m
Finished!
"/1
Number | 1 | 2 | 3 | |
4 | 5 | 6 | ||
buttons | ||||
7 | 8 | 9 | ||
| ||||
|
| 0 |
|
M/m/</,,
ENTER
O RETURN 
Settings and Hookups
1
2
Turn on the TV.
Press "/1.
The recorder turns on.
,continued 23US