Programming the remote

You can program the remote to control non-Sony components by changing the code. Once the control signals have been memorized, you can use those components as part of your system. Furthermore, you can also program the remote for Sony components that the remote is unable to control. Note that the remote can only control components that accept infrared wireless control signals.

RM SETUP

AV ?/1

Input buttons

Numeric buttons

CLEAR ENTER -

ENTER

m M . >

H X x

1 Press AV ?/1 while holding down RM

SETUP.

The indicator lights up.

Note

•Press the RM SETUP button using a pointed object.

2 Press the input button for the component you want to control.

For example, if you are going to control a DVD player, press DVD.

3 Press the numeric buttons to enter the numeric code (or one of the codes if more than one code exists) corresponding to the component and the maker of the component you want to control.

See the tables on pages 12–14 for information on the numeric code(s) corresponding to the component and the maker of the component (the first digit and the last two digits of the numeric code correspond to the category and the maker’s code respectively).

4 Press ENTER.

Once the numeric code has been verified, the indicator slowly flashes twice and the remote automatically exits the programming mode.

5 Repeat steps 1 to 4 to control other components.

To cancel programming

Press RM SETUP during any step. The remote automatically exits the programming mode.

To activate the input after programming

Press the programmed button to activate the input you want.

If programming is unsuccessful, check the following:

•If the indicator does not light up in step 1, the batteries are weak. Replace both batteries.

•If the indicator flashes 4 times in quick succession while entering the numeric code, an error has occurred. Start again from step 1.

Note

•The indicator turns off while a valid button is pressed.

•In step 2, if several input buttons are pressed, only the last pressed button is valid.

•In step 2, if you press TV ?/1, only TV VOL +/– , TV CH +/–, TV/VIDEO and WIDE buttons are reprogrammed.

•In step 3, if an input button is pressed, the new input is selected and the programming procedure returns to the beginning of step 3.

•For the numeric codes, only the first three numbers entered are valid.

To clear the memory of the remote

To clear all programmes, do the following to reset the remote to factory settings.

Press VOLUME –, ?/1 and AV ?/1 at the same time.

The indicator flashes 3 times, then goes off.

continued

components connected the Controlling

11US