Do not step on the stand.
If you do so, you may fall from the stand resulting in injury.
This stand is only for the specified TV.
•Do not place unspecified objects, such as a flower vase or pottery on the stand.
•Do not make alterations to the stand.
Secure the TV to the stand.
If you fail to do so, the TV may fall or the stand may topple over. This may cause injury. Following the instructions in this manual, place the TV legs into the stopper and use the support belt to prevent the TV from toppling over.
Note on load capacity
Do not place any equipment exceeding the specified maximum weight on the stand, as indicated in the illustration below. Otherwise, it may fall or break.
65 kg (143 lb 5 oz)
16 kg (35 lb 5 oz) 
25 kg (55 lb 2 oz) 
Notes on installation
•Be careful not to pinch your hand or fingers between the TV and the stand.
•To prevent the stand from distorting, observe the following:
–Install the stand on a solid and flat surface.
–If you install the stand on a soft surface such as a mat, first lay a board under the stand.
–Do not install the stand in a place subject to direct sunlight or near a heater.
–Do not install the stand in a hot or humid place, or outdoors.
•Moving the stand requires four people or more. Move the stand only after removing the TV. If you fail to do so, the TV may fall from the stand resulting in serious injury. Do not hold the grille as it may detach from the stand resulting in serious injury. Be careful not to pinch your fingers when moving the stand.
Notes on use
•Do not place any hot objects on the stand. If you do so, the stand may discolor or distort.
•To keep the stand clean, occasionally wipe the stand gently with a dry, soft cloth. Stubborn stains may be removed with a cloth slightly dampened with diluted detergent, followed by a soft dry cloth. Do not use any type of chemicals, such as thinner or benzine, as they may damage the finish of the stand.
•When placing the top front cover on the floor after removing it from the stand, cover the floor with a cloth, etc., beforehand to protect the floor from damage.
Inserting batteries into the remote
You can control the system using the supplied remote. Insert two size AA (R6) batteries by matching the + and − ends on the batteries to the markings inside the compartment.
Note
•Do not leave the remote in an extremely hot or humid place.
•Do not use a new battery with an old one.
•Do not drop any foreign object into the remote casing, particularly when replacing the batteries.
•Do not expose the remote sensor to direct light from the sun or lighting apparatus. Doing so may cause a malfunction.
•If you do not intend to use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.
6US