Getting

Started

This section describes how to hook up the system to the speakers, a TV monitor with audio/video input jacks and other video component. You cannot connect this system to a TV monitor which does not have a video input connector. Be sure to turn off the power of each component before making the connections.

Unpacking

Check that you have the following items:

•AM loop antenna (1)

•FM wire antenna (1)

•Speakers (5)

•Subwoofer (1)

•Speaker cords (5 m x 4, 15 m x 2)

•Video cord (1)

•Remote commander (remote) RM-SS300 (1)

•R6 (size AA) batteries (2)

•Foot pads (24)

•Speakers - Connection and Installation (card) (1)

•21-pin adaptor (1) (only for the European models)

Inserting batteries into the remote

You can control the system using the supplied remote. Insert two R6 (size AA) batteries by matching the + and – on the batteries. When using the remote, point it at the remote sensor gon the system.

zYou can control TVs using the supplied remote

See page 51.

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use a new battery with an old one.

•Do not drop any foreign object into the remote casing, particularly when replacing the batteries.

•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•If you will not use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Started Getting

7