Package Contents

After opening the package, make sure that all the following items are present.Contact your dealer if anything is missing.S-AIT Tape Drive Unit (1)S-AIT Data Cartridge SAIT1-500 (1)S-AIT Cleaning Cartridge SAIT1-CL (1)Air filter unit (1)Quick start guide (1)CD-ROM (1)(containing the operating instructions and device drivers)SCSI terminator (1) (SAITe1300-S only)

Notes

In addition to the above, other items may be included in the package.

All the items included with the S-AIT Tape Drive unit are indicated on the package.

Setting the DIP Switches

Refer to the “Operating Instructions” (PDF) and perform the data compression settings using the DIP switches at the bottom of the S-AIT Tape Drive Unit.

The default settings of the DIP switches is as follows.DC Control-1: ON Compression is enabled.DC Control-2: OFFThe host can control compression.
Setting the SCSI ID (SAITe1300-S only)

If necessary, perform the SCSI ID settings using the SCSI ID switches on the rear of the S-AIT Tape Drive Unit.

The default SCSI ID of the SAITe1300-S is 0. (The unit can be configured to SCSI ID addresses ranging from 0 to 15.)

For details, refer to the “Operating Instructions” (PDF).Setting the Loop ID (SAITe1300-F only)

If necessary, perform the Loop ID settings using the loop ID jumpers on the rear of the S-AIT Tape Drive Unit. These jumpers are functional when the topology is arbitrated loop.

For details, refer to the “Operating Instructions” (PDF).

GB

Package Contents / Setting the Loop ID (SAITe1300-F only)

17