Installing the S-AIT Tape Drive Unit

The S-AIT Tape Drive Unit weights about 7 kg (15.4 lb.) and has the following dimensions. Make sure that the surface where you will install the S-AIT Tape Drive Unit is appropriate before installing the unit.

Note

Install the S-AIT Tape Drive Unit on a horizontal surface near an AC power outlet. Make sure that you leave gap of about 150 mm (5.9 in.) behind the rear of the unit to allow air to circulate.

86 mm (3.4 in.)

370 mm (14.6 in.)

210mm

(8.3 in.)

50 mm (2.0 in.)

Rear

210 mm (8.3 in.)

Front 150 mm

370 mm (14.6 in.) (5.9 in.)

50 mm (2.0 in.)

Recommended positioning of the unit
•Always position the unit horizontally.•Away from moving air, such as fans, open windows, or air conditioners.•Away from devices such as facsimiles to avoid toner and paper dust.

The S-AIT Tape Drive Unit should not be stacked. Do not place anything on top of the unit.

Connecting the Power Cable

1 Verify the power cable plug to make sure that it matches the AC IN connector receptacle.

2 Make sure that the electrical outlet you use to connect the unit is properly grounded.

3 Connect one end of the power cable to the AC IN connector and the other end to the power outlet.

Note

If the S-AIT drive does not come with a power cable, make sure that you connect a power cable appropriate for your country to this connector.

AC Power

Installing Device Drivers

A device driver is host firmware that allows the S-AIT Tape Drive Unit to interact with a variety of hosts.

If your software requires it, install the appropriate device driver for your system from the supplied CD-ROM. Refer to the instructions on the CD-ROM to install device drivers.

The latest device drivers and documentation for the S- AIT Tape Drive Units are available online. Contact your dealer for details.

18 Installing the S-AIT Tape Drive Unit / Installing Device Drivers