1 Press the CODE SET button on the DSS remote control.
2 Using the number buttons on the DSS remote control, enter the
3 Press the ENTER button on the remote control.
The RF security code is now changed for both the DSS receiver and remote control.
You can determine the current RF security code for the DSS remote control using the IDENTIFY button in the Set Up Remote screen.
1 Bring up the Set Up Remote screen, as described on page 71.
2 Select IDENTIFY.
SET UP REMOTE
|
| OK | |
REMOTE SIGNAL | IR ONLY | ||
| |||
| |||
|
| CANCEL | |
|
|
| |
|
|
| |
RF SECURITY CODE | 000 | IDENTIFY | |
| |||
|
| HELP | |
|
| ||
|
|
| |
REMOTE CODES |
|
| |
|
|
|
Press the joystick within 5 seconds.
3 When the message “Press the joystick within 5 seconds” appears, press the joystick before the 5 seconds expire.
The current RF security code for the DSS remote control appears.
SET UP REMOTE
|
| OK | |
REMOTE SIGNAL | IR ONLY | ||
| |||
| |||
|
| CANCEL | |
|
|
| |
|
|
| |
RF SECURITY CODE | 000 | IDENTIFY | |
| |||
|
| HELP | |
|
| ||
|
|
| |
REMOTE CODES |
|
| |
|
|
|
Your remote is currently set at 000.
Note
If the message, “Security code could not be identified” appears, check to make sure that RF is enabled and that the RF antenna is connected properly. See “Selecting IR/RF Transmission
4 Select OK to return to the Setup Menu.
Chapter 6: Using the Setup Menu 73