Appendix: Other Information
If the indicator doesn’t flash, repeat steps 4 and 5.
To learn other functions, repeat steps 4 and 5.
The Learn function does not work in the VTR1 and VTR2 slide switch positions.
During the learning procedure, do not move the remote controls.
If you press a button on this remote commander that cannot be used for learning, the Learn indicator flashes four times.
To clear all learned signals from memory, set the slide switch inside the lid to MDP, press the LEARN button, press the DSS POWER button while holding down the VOL- button, and then press the LEARN button again.
When you remove the batteries — to replace them, for example — any codes you’ve set may be erased.
Using the Learn Function (SAT-A2 Only)
You can program the DSS remote commander to learn the functions of another component’s remote control. Use this function to operate components that are not listed in “Programmable Codes” on page 86.
To use the Learn function:
1 Set the slide switch in the inside panel to VTR3 or MDP.
2 Place the DSS remote commander and the other component’s remote control directly facing each other, about two inches apart.
Approx. 2 inches
3 Press the LEARN button. The Learn indicator lights.
4 Press the button on the DSS remote commander that you want to learn a function. The Learn indicator flashes off, then on, indicating that the DSS remote commander is now ready to learn.
5 Hold down the corresponding button on the other component’s remote control. When the Learn indicator flashes off, then on, release the button on the other component’s remote control.
6
About the Learn Function87