SERVICE MANUAL |
| |
US Model | ||
Ver. 1.0 2004.12 | Canadian Model | |
AEP Model | ||
| ||
| UK Model | |
| E Model |
SPECIFICATIONS
AUDIO POWER SPECIFICATIONS (US MODEL)
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
200 watts per channel minimum continuous average power into
4 ohms, both channels driven from 20 Hz to 20 kHz with no more than 0.1% total harmonic distortion per Car Audio Ad Hoc Committee standards.
Other Specifications
Circuit system | OTL (output transformerless) circuit |
| Pulse power supply |
Inputs | RCA pin jacks |
| High level input connector |
Outputs | Speaker terminals |
| Through out pin jacks |
Suitable speaker impedance | |
| 2 – 8 Ω (stereo) |
| 4 – 8 Ω (when used as a bridging amplifier) |
Maximum outputs | 400 W ⋅ 2 (at 4 Ω) |
| 600 W ⋅ 2 (at 2 Ω) |
| 1,200 W (BTL, at 4 Ω) |
Rated outputs (supply voltage at 14.4 V) | |
| 200 W RMS ⋅ 2 (20 Hz – 20 kHz, |
| 0.1% THD + N, at 4 Ω) |
| 250 W RMS ⋅ 2 (20 Hz – 20 kHz, |
| 0.15% THD + N, at 2 Ω) |
| 500 W RMS (BTL) (20 Hz – 20 kHz, |
| 0.15% THD + N, at 4 Ω) |
SN Ratio | 93 dBA (Reference 1W into 4 Ω) |
Frequency response | 5 Hz – 50 kHz ( |
Input level adjustment range
| 0.3 – 6.0 V (RCA pin jacks) |
| 1.2 – 12.0 V (High level input) |
50 – 300 Hz, | |
Low boost | 0 – 10 dB (40 Hz) |
Power requirements | 12 V DC car battery |
| (negative ground) |
Power supply voltage | 10.5 – 16 V |
Current drain | at rated output : 48 A (at 4 Ω) |
| Remote input : 1 mA |
Dimensions | Approx. 403 ⋅ 55 ⋅ 277 mm |
| (15 7/8 ⋅ 2 1/4 ⋅ 11 in.) |
| (w/h/d) not incl. projecting parts and controls |
Mass | Approx. 5 kg (11 lb. 1 oz.) not incl. accessories |
Supplied accessories | Mounting screws (4) |
| High level input cord (1) |
| Protection cap (1) |
Design and specifications are subject to change without notice.
STEREO POWER AMPLIFIER
Sony Corporation | |
e Vehicle Company | |
© 2004.12 | Published by Sony Engineering Corporation |
1
