Step 6: Turn on the monitor and

Using the stereo speakers

computer

You can listen to music, sound, and other audio files using the

 

stereo speakers of your monitor.
1Press the 1 (power) switch.The indicator of the monitor lights upAdjustinggreenthe volume.

Volume adjustments are made using a separate VOLUME menu from the main menu (page 11).

1 Press the 2 +/– buttons.The VOLUME menu appears on the screen.

VOL UME

2Turn on the computer.

The installation of your monitor is complete If necessary, usethe 4 0 monitor’s controls to adjust the picture.

If no picture appears on your screen
•Check that the monitor is correctly connected to the computer.•If NO INPUT SIGNAL appears on the screen:

–The computer is in the power saving mode. Try pressing any key on the keyboard or moving the mouse.

–Check that the input signal setting is correct.–Check that the digital/analog select switch setting is correct.•If CABLE DISCONNECTED appears on the screen:–Check that the video signal cable is properly connected.

–Check that the input signal setting is correct.

•If OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer’s graphics board so that the horizontal frequency is between 28 – 92 kHz, and the vertical frequency is between 48 – 85 Hz.

2Press the 2 +/– buttons to adjust the volume.The menu automatically disappears after about 5 seconds.Using the headphones jackYou can listen to the audio signals from your computer or otherGB

audio equipment using headphones. Connect your headphones to the headphones jack. The speakers turn off when headphones are connected to the headphones jack. Adjust the volume of the headphones using the VOLUME menu.

Notes

For more information about on-screen messages, see “Trouble symptoms and remedies” on page 19.

No need for specific drivers

The monitor complies with the “DDC” Plug & Play standard and automatically detects all the monitor’s information. No specific driver needs to be installed to the computer.

The first time you turn on your computer after connecting the monitor, the setup Wizard may appear on the screen. In this case, follow the on-screen instructions. The Plug & Play monitor is automatically selected so that you can use this monitor.

The vertical frequency turns to 60 Hz.

Since flickers are unobtrusive on the monitor, you can use it as it is. You do not need to set the vertical frequency to any particular high value.

If your computer or graphics board has difficulty communicating with this monitor, install the information file for this monitor using the Windows Monitor Information Disk. For details on installing, refer to the ReadMe file on the disk.

•You cannot adjust the volume when displaying the main menu on the screen.

•When your monitor is in power saving mode, no sound comes from the speakers or the headphones.

Selecting the input signal

You can connect two computers to this monitor using the INPUT1 and INPUT2 connectors. To select one of the two computers, use the INPUT button.

Press the INPUT button.

The input signal and corresponding input indicator change each time you press this button.

•1: Input via the DVI-I (digital/analog RGB) input connector•2: Input via the HD15 (analog RGB) input connector

INPUT

1

2

OK

Note

You cannot select the input signal when displaying the main menu on the screen.

9