•If “OUT OF RANGE” appears on the screen:

Reconnect the old display. Then adjust the computer’s graphics board within the following ranges.

 

Analog RGBDigital RGB
Horizontal28–80 kHz28–64 kHz
frequency

 

 

 

 

 

Vertical48–75 Hz60 Hz

frequency

 

 

 

 

 

Resolution1280 ⋅ 1024 or less

 

 

 

 

For more information about the on-screen messages, see “Trouble symptoms and remedies” on page 18.

No need for specific drivers

The display complies with the “DDC” Plug & Play standard and automatically detects all the display’s information. No specific driver needs to be installed to the computer.

The first time you turn on your computer after connecting the display, the setup Wizard may appear on the screen. If this is the case, follow the on- screen instructions. The Plug & Play display is automatically selected so that you can use this display.

The vertical frequency turns to 60 Hz.

Since flickers are unobtrusive on the display, you can use it as is. You do not need to set the vertical frequency to any particular high value.

Setup 7:Adjust the tilt and height

This display can be adjusted within the angles shown below.Hold both sides of the LCD panel, then adjust screen angles.
approx. 5°

approx. 20°

approx.175°approx. 175°

When you use the height adjustable stand, the height adjust is also available as below.

Hold both sides of the LCD panel, then adjust screen height.approx. 110 mm (4 11/32 inches)To use the display comfortably

Adjust the viewing angle of your display according to the height of your desk and chair, so that light is not reflected from the screen to your eyes.

Notes

•When adjusting the screen’s angle, be sure not to crash it against any objects around the display.

•Do not put any objects under the display when you adjust the height of stand. It may get damaged by accident.

10