| Symptom | Remedy | |
|
|
| |
| The timer does not | • Check that the clock is set. | |
| operate. | • Make sure a tape has been inserted. | |
|
| • Check that the safety tab has not been removed. | |
|
| • Make sure the tape is not at its end. | |
|
| • Make sure a programme has been set for timer recording. | |
|
| • Make sure your timer settings are past the current time. | |
|
| • Check that the decoder is turned on. | |
recording |
| • Check that the satellite tuner is turned on. | |
| • The clock stops if the VCR is disconnected from the mains | ||
| for more than one hour. Reset the clock and timer. | ||
| • Turn the power off and unplug the mains lead. | ||
|
| ||
Timer | The SHOWVIEW menu | • Check that OPTIONS PROGRAMM. in the | |
or the MINUTERIE | menu is set correctly (see page 84). | ||
menu does not appear. |
| ||
|
| ||
|
|
| |
| The VPS/PDC function | • Check that the clock and the date are set correctly. | |
| does not operate | • Check that the VPS/PDC time you set is the correct one | |
| properly. | (there might be a mistake in the TV programme guide). If | |
|
| the broadcast you wanted to record did not send the good | |
|
| VPS/PDC information, the VCR will not start recording. | |
|
| • If the reception is poor, the VPS/PDC signal might be | |
|
| altered and the VCR might not start recording. | |
|
|
| |
| The ENR SYNCHRO | • The tape has reached its end. Insert a new tape and press | |
| button turns off while | ENR SYNCHRO again. | |
Recording | recording or does not go |
| |
back to recording |
| ||
standby mode. |
| ||
|
| ||
The Synchronized | • The connected equipment was not turned off. | ||
Recording function does | Turn off the connected equipment and press ENR | ||
Synchronized | |||
not work. | SYNCHRO again. | ||
| • There was a power failure. Press ENR SYNCHRO again. | ||
|
| ||
The programme recorded | • If the settings for timer recordings and Synchronized | ||
with the Synchronized | Recording overlap, the programme that starts first has | ||
Recording function is | priority and the second programme starts recording only | ||
| incomplete. | after the first programme has finished. | |
|
| • There was a power failure. Press ENR SYNCHRO again. | |
|
|
| |
Plus | You cannot set the | • Check that DECODEUR/LIGNE3 (or DECODEUR/ | |
channel as the Canal Plus | LIGNE2) in the | ||
Canal | in the REGLAGE DES | ||
CHAINES menu. |
| ||
|
| ||
|
|
|
92Troubleshooting