How to Control the Display from the
For the projectors that the
PROJECTOR CONTROL RS-232C Terminal
To connect the
This model can switch the input signals and power ON/STANDBY of the projector and plasma display in interlocked condition.
<Sony projector/ |
| |
plasma display side> | ||
|
Pin No. | Signal | Function |
1 | FG | Frame ground |
2 | RD | Receive data |
3 | TD | Send data |
4 | ER | Not connected |
5 | SG | Signal line ground |
6 | DR | Not connected |
7 | RS | Not connected |
8 | CS | Not connected |
9 | N. C | Not connected |
Pin No. | Signal | Function |
1 | FG | Frame ground |
2 | RX DA | Receive data |
3 | TX DA | Send data |
4 | DTR | Data terminal ready |
5 | GND | Ground |
6 | DSR | Data set ready |
7 | RTS | Request to send |
8 | CTS | Clear to send |
9 | RI | Called display |
PROJECTOR CONTROL CONTROL S IN/OUT Terminal
The
Remote
projector as interlocked operation. The RGB signal and the component signal cannot be connected at the same time for the interlocked operation. Connect the wired remote commander supplied with a projector to the CONTROL S IN terminal. Then you can establish various setups of a projector from the
PROJECTOR
IN
OUT
Projector
How to Control the SRP-X700P from External Equipment
Note
The USB terminal and the REMOTE USB terminal are the dedicated terminal to control this unit from the
REMOTE RS-232C Terminal
Use of this terminal enables you to control the
Terminal shape | : |
Electrical specifications | : Conforms to |
Recommended cable | : |
Cable length | : 15 m or less |
Communication format |
|
Baud rate | : 9600 bps |
Bit length | : 8 bits |
Stop bit | : 1 bit |
Parity | : ODD (odd number) |
Note
Use the null modem cable when connecting the
Pin No. | Signal | Function |
1 | FG | Frame ground |
2 | RD | Receive data |
3 | TD | Send data |
4 | ER | Not connected |
5 | SG | Signal line ground |
6 | DR | Not connected |
7 | RS | Not connected |
8 | CS | Not connected |
9 | N. C | Not connected |
9