Sony STR-D550Z, STR-D650Z manual Unpacking, Hookup Overview, Inserting batteries into the remote

Getting Started

Unpacking

Check that you received the following items with the receiver:

•FM wire antenna (1)

•AM loop antenna (1)

•Remote commander (remote) (1)

•Size AA (R6) batteries (2)

•Audio/Video cable (1)

(USA and Canadian STR-DE705 only)

•Control S cord (1)

(USA and Canadian STR-DE705 only)

Inserting batteries into the remote

Insert two size AA (R6) batteries with the + and – on the battery compartment. When using the remote, point it at the remote sensor gon the receiver.

When to replace batteries

Under normal use, the batteries should last for about 6 months. When the remote no longer operates the receiver, replace both batteries with new ones.

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use a new battery with an old one.

•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•If you don’t use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Hookup Overview

The receiver allows you to connect and control the following audio/video components. Follow the hookup procedures for the components that you want to connect to the receiver on the pages specified. To learn the locations and names of each jacks, see “Rear Panel Descriptions” on page 26.

				Antenna Hookups (5)
Speaker		TV/VCR Hookups (7, 8)		AM/FM antenna
System
Hookups (6, 7)			TV
Front						Front
			VCR
speaker						speaker
					Active
	(L)						(R)
			LD player		woofer

	CD player	Center
		speaker
Rear	Tape deck		Rear
speaker			speaker
(L)	DAT/MD deck		(R)

Turntable

Audio Component

Hookups (5, 6)

Before you get started

•Turn off the power to all components before making any connections.

•Do not connect the AC power cords until all of the connections are completed.

•Be sure to make connections firmly to avoid hum and noise.

•When connecting an audio/video cable, be sure to match the color-coded pins to the appropriate jacks on the components: Yellow (video) to Yellow; White (left, audio) to White; and Red (right, audio) to Red.

4EN