Broadcasts Receiving

Preset Tuning

For details on the buttons used in this section, see “Brief descriptions of buttons used to receive broadcasts” on page 49.

Before tuning to preset stations, be sure to preset them by performing steps on “Presetting radio stations” below.

Presetting radio stations

1Turn INPUT SELECTOR to select TUNER.

The last received station is tuned in.

2Tune in the station that you want to preset using Automatic/Manual Tuning (page 49) or Direct Tuning using the remote (page 51).

3Press MEMORY.

“MEMORY” appears in the display for a few seconds. Do Steps 4 and 5 before “MEMORY” goes out.

4Press TUNER PRESET + or – to select a preset number.

5Press MEMORY again to store the station.

If “MEMORY” goes out before you can store the station, start again from Step 3.

6Repeat Steps 2 to 5 to preset another station.

To change a preset number to another station

Do Steps 1 to 5 to preset the new station to the number.

Clearing preset stations

1Press TUNER to activate the tuner menu.

2 Press the cursor buttons ( or ) to display “PRESET CLEAR [NO]”.

3Turn the jog dial to display “PRESET CLEAR [YES]” and press ENTER.

“Are you sure? [No]” is displayed.

4Once again, turn the jog dial to display “[YES]” and press ENTER.

Tuning to preset stations

You can tune the preset stations either of the following two ways.

Scanning the preset stations

1Turn INPUT SELECTOR to select TUNER.

The last received station is tuned in.

2Press TUNER PRESET + or TUNER PRESET – repeatedly to select the preset station you want.

Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:

nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N￿

nC0˜...C2˜C1N

50