Information Additional
Troubleshooting
No sound is heard from the center speaker.
/Make sure the sound field function is on (press A.F.D.).
/Select a sound field containing the word “cinema” or “virtual” (see page 30~32).
/Adjust the speaker volume (see page 21).
/Make sure the center speaker size parameter is set to either SMALL or LARGE (see page 18).
No sound or only a very
/Make sure the sound field function is on (press A.F.D.).
/Select a sound field containing the word “cinema” or “virtual” (see page 30~32).
/Adjust the speaker volume (see page 21).
/Make sure the rear speaker size parameter is set to either SMALL or LARGE (see page 19).
Recording cannot be done.
/Check that the components are connected correctly.
/Select the source component by rotating the INPUT SELECTOR control.
/When recording from a digital component, be sure to press DIGITAL/ANALOG to select “ANALOG” (see page 25) before recording with a component connected to the analog MD/DAT, TAPE, VIDEO 1, VIDEO 2, or VIDEO 3 terminals.
/When recording from a digital component, be sure to press DIGITAL/ANALOG to select “DIGITAL” (see page 25) before recording with the component connected to the MD/DAT OPT OUT terminals.
The surround effect cannot be obtained.
/Make sure the sound field function is on (press A.F.D.).
/Make sure that the SPEAKERS selector is set to A or B (not A+B) if you connected two sets of front speakers.
The front panel door stops suddenly while opening or closing.
/If an external force is applied to the door while it is opening or closing, it stops automatically for safety reasons. Remove the cause of the external force, then press OPEN/CLOSE again (see page 27).
Radio stations cannot be tuned in.
/Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.
/The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.
/Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning) (see pages 51).
/No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (see page 50).
No picture or an unclear picture appears on the TV screen or monitor.
/Select the appropriate function on the receiver.
/Set your TV to the appropriate input mode.
/Move your TV away from the audio components.
The audio output does not correspond to the video image on the TV screen or monitor.
/Check the source of the audio signal by pressing AUDIO SPLIT to display "V:(video component) A:(audio component)". Hold down AUDIO SPLIT for more than 2 seconds to cancel the function and restore both audio and video to the selected video component.
The remote does not function.
/Point the remote at the remote sensor 
on the receiver.
/Remove any obstacles in the path between the remote and the receiver.
/Replace all batteries in the remote with new ones, if they are weak.
/Make sure you select the correct function on the remote.
/If the remote is set to operate the TV only, use the remote to select a source or component other than TV before operating the receiver or other component.
Reference sections for clearing the
receiver’s memory
To clear | See |
All memorized settings | Page 17 |
|
|
Customized equalizers | Page 47, 53 |
|
|
58