Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from 20 – 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output.
Amplifier section
Power Output
Models of area code U, CA Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
125 W + 125 W1)
Models of area code CEL, CEK Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
100 W + 100 W1)
1) Measured under the following conditions:
Area code | Power requirements |
U, CA | 120 V AC, 60 Hz |
|
|
CEL, CEK | 230 V AC, 50 Hz |
|
|
Frequency response |
|
|
|
CD, MD/TAPE, | 20 Hz – 50 kHz |
VIDEO 1, 2 | |
| boost and tone bypassed) |
|
|
Inputs (Analog) |
|
|
|
CD, MD/TAPE, | Sensitivity: 500 mV |
VIDEO 1, 2 | Impedance: 50 kiloohms |
| S/N2): 85 dB |
| (A, 500 mV3)) |
2)INPUT SHORT (with bass boost and tone bypassed).
3)Weighted network, input level.
Outputs (Analog)
MD/TAPE (OUT), | Voltage: 500 mV |
VIDEO 1 (AUDIO OUT) | Impedance: 10 kiloohms |
|
|
Bass Boost: | +8 dB at 70 Hz |
Tone: | ±10 dB at 100 Hz and |
| 10 kHz |
FM tuner section |
|
Tuning range | 87.5 – 108.0 MHz |
Antenna | FM wire antenna |
Antenna terminals | 75 ohms, unbalanced |
Intermediate frequency | 10.7 MHz |
Sensitivity |
|
Mono: | 18.3 dBf, 2.2 µV/75 ohms |
Stereo: | 38.3 dBf, 22.5 µV/75 ohms |
Useable sensitivity | 11.2 dBf, 1 µV/75 ohms |
S/N |
|
Mono: | 76 dB |
Stereo: | 70 dB |
Harmonic distortion at 1 kHz | |
Mono: | 0.3% |
Stereo: | 0.5% |
Separation | 45 dB at 1 kHz |
Frequency response | 30 Hz – 15 kHz, |
| |
Selectivity | 60 dB at 400 kHz |
AM tuner section
Tuning range
Models of area code U, CA
With | – | 1,710 kHz4) | |
With | 531 | – | 1,710 kHz4) |
Models of area code CEL, CEK |
| ||
With | 531 | – | 1,602 kHz |
Antenna | Loop antenna | ||
Intermediate frequency | 450 kHz | ||
Usable sensitivity | 50 dB/m (at 1,000 kHz or | ||
| 999 kHz) | ||
S/N | 54 dB (at 50 mV/m) | ||
Harmonic distortion | 0.5% (50 mV/m, 400 Hz) | ||
Selectivity |
|
|
|
At 9 kHz: | 35 dB |
| |
At 10 kHz: | 40 dB |
| |
4)You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. While holding down PRESET TUNING +, press ?/1. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure.
26GB