Multi channel surround setup (continued)
When placing surround speakers behind you
(wide room)
B
A A
45°
C | C |
90°
20°
Note
Do not place the center speaker further away from the listening position than the front speakers.
Normal Speaker and Micro Satellite Speaker
If you are using | Select |
Normal Speakers | NORM. SP. |
|
|
Micro Satellite Speakers | MICRO SP. |
|
|
The speaker size and the sub woofer selection has been preset to “NORM. SP.”. You can adjust the speaker size and sub woofer selection when you select “NORM. SP.” (page 17).
To select “MICRO SP.”, turn off the power, then turn on again while pressing MAIN MENU. (To reset to “NORM. SP.”, do the same procedure.)
When you select “MICRO SP.”, the speaker size and sub woofer selection has been configurated as follows:
Speaker | Settings |
FRONT | SMALL |
|
|
CENTER | SMALL |
|
|
SURROUND | SMALL |
|
|
SUB WOOFER | YES |
|
|
You cannot change the configuration if you select “MICRO SP.”.
Tip
The setting for Micro Satellite Speaker (MICRO SP.) has been programmed to optimize the sound balance. If you use Sony’s Micro Satellite Speakers, select “MICRO SP.”.
Caution
When you use Micro Satellite Speakers and the speaker size is set to “LARGE”, you may not obtain the correct soundstage. The speaker may also be damaged at high volume position.
Specifying the speaker parameters
1 Press MAIN MENU repeatedly to select “
SET UP
”.
2 Press MENU 
or MENU 
to select
the parameter you want to adjust.
3 Press MENU + or MENU – to select the setting you want.
The setting is entered automatically.
4 Repeat steps 2 and 3 until you have set all of the parameters that follow.
Initial settings
Parameter | Initial setting | |
SW (SUB WOOFER) S.W. XXX | YES* | |
|
|
|
L | R (FRONT) XXXXX | LARGE* |
|
|
|
C | (CENTER) XXXXX | LARGE* |
|
|
|
SL | SR (SURROUND) XXXXX | LARGE* |
|
|
|
L | R DIST. X.X m (XX ft.)** | 3.0 m (10 ft.)** |
|
|
|
C | DIST. X.X m (XX ft.)** | 3.0 m (10 ft.)** |
|
|
|
SL | SR DIST. X.X m (XX ft.)** | 3.0 m (10 ft.)** |
|
|
|
SL | SR PL. XXXX | LOW |
|
|
|
*You can set this parameter only when you select “NORM. SP.”.
**The default unit for models of area code U, CA is “ft.”.
The default unit for models of other area code is “m”.