Presetting radio stations
1
2 Tune in the station that you want to preset using Direct Tuning (page 29) or Automatic Tuning (page 30).
3 Press MEMORY.
“MEMORY” appears in the display for a few seconds.
Do steps 4 to 5 before “MEMORY” goes out.
4 Press PRESET TUNING + or PRESET TUNING – repeatedly to select a preset station number.
Each time you press the button, the preset station number changes in the corresponding number and direction as follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
If “MEMORY” goes out before you select the preset station number, start again from step 3.
5 Press MEMORY again to store the station.
If “MEMORY” goes out before you can store the station, start again from step 3.
6 Repeat steps 2 to 5 to preset another station.
To change a preset number to another station
Do steps 1 to 5 to preset a new station to the number.
Tip
In step 4, you can also use the remote to select a preset station number. Press SHIFT repeatedly to select a memory page (A, B or C) and then press the numeric buttons to select a preset number.
Tuning to preset stations
You can tune the preset stations by either of the following two ways.
Scanning the preset stations
1 Press TUNER FM/AM.
The last received station is tuned in.
2 Press PRESET TUNING + or PRESET
TUNING – repeatedly to select the preset station you want.
Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
Using the preset codes
Use the supplied remote to perform the following operations. For details on the buttons used in this section, see pages
1 Press TUNER on the remote.
The last received station is tuned in.
2 Press SHIFT to select a memory page (A, B, or C), then press the preset number of the station you want using the numeric buttons.
Broadcasts Receiving