FM tuner section
Tuning range 87.5 - 108.0 MHz
Antenna terminals
75 ohms, unbalanced
Sensitivity Mono: 18.3 dBf,
2.2 ∝ V/75 ohms
Stereo: 38.3 dBf,
22.5 ∝ V/75 ohms
Usable sensitivity
11.2 dBf, 1 ∝ V/75 ohms
S/N | Mono: 76 dB |
| Stereo: 70 dB |
Harmonic distortion at 1 kHz
Mono: 0.3%
Stereo: 0.5%
Separation 45 dB at 1 kHz
Frequency response
30 Hz – 15 kHz
Selectivity 60 dB at 400 kHz
AM tuner section
Tuning range
Models of area code U, CA With
scale:
530 – 1710 kHz6) With
scale:
531 – 1710 kHz6) Models of area code AU, CN, SP With
scale:
531 – 1602 kHz
Models of area code E
With
530– 1610 kHz6) With
scale:
531– 1602 kHz6)
Antenna | Loop antenna |
Usable sensitivity
50 dB/m (at 1,000 kHz or 999 kHz)
S/N | 54 dB (at 50 mV/m) |
Harmonic distortion
0.5% (50 mV/m, 400 kHz)
Selectivity At 9 kHz: 35 dB At 10 kHz: 40 dB
6)You can change the AM tuning scale to
9 kHz y 10 kHz. After tuning in any AM station, turn off the receiver. Hold down the TUNING + button and press the ?/1 button. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure.
Video section
Inputs Video: 1
Y:1
C:0.286
75 ohms
Outputs Video: 1
Y:1
C:0.286
75 ohms
General
System | Tuner section: |
| PLL |
| digital synthesizer |
| system |
| Preamplifier section: |
| |
| equalizer |
| Power amplifier |
| section: |
| |
| SEPP |
Power requirements
Models of area code U,
CA
120 V AC, 60 Hz Models of area code
CN, SP
220 – 230 V AC, 50/60 Hz
Models of area code AU 240 V AC, 50 Hz Models of area code E 120/220/240 V AC,
50/60 Hz
Power consumption
Models of area code U
Models of area code CA
Models of area code
CN, SP
Models of area code AU
Models of area code E
•Abbreviation
AU : Australian model
CA : Canadian model
CN : Chinese model
AC outlets
Models of area code U,
CA
2switched, total 120 W/1A
Models of area code
AU, SP
1switched, total 100 W
Models of area code E,
CN
2switched, total 100 W
Dimensions 430 ⋅ 158 ⋅ 378 mm (17 ⋅ 61/4 ⋅ 15 in.) including projecting parts and controls
Mass (Approx.)
10.3 kg (22 lb 12 oz)
Supplied accessories
•FM wire antenna (1)
•AM loop antenna (1)
•LR6
•Audio/video/control S connecting cord (1)
•Control S connecting cord (1)
•Remote commander
•Remote commander
Design and specifications are subject to change without notice.
MY : Malaysia model
SP : Singapore model
U : US model
Notes on chip component replacement
•Never reuse a disconnected chip component.
•Notice that the minus side of a tantalum capacitor may be dam- aged by heat.
Flexible Circuit Board Repairing
•Keep the temperature of the soldering iron around 270 ˚C during repairing.
•Do not touch the soldering iron on the same conductor of the circuit board (within 3 times).
•Be careful not to apply force on the conductor when soldering or unsoldering.
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS AP- PEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB- LISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!
LES COMPOSANTS IDENTIFÉS PAR UNE MARQUE 0 SUR LES
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
2
