PROTECT
Irregular current is output from the speakers. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again.
If you are unable to remedy the problem using the troubleshooting guide
Clearing the receiver’s memory may remedy the problem (page 25). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing the receiver’s memory
To clear | See |
All memorized settings | |
|
|
Customized sound fields | page 53 |
|
|
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U only)
With 8 ohm loads, both channels driven, from 20 – 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output.
Amplifier section Models of area code U, CA
Stereo Power Output1), Reference Power Output1)2)
8 ohms 20 Hz – 20 kHz, THD 0.09%
100 W + 100 W, 110 W/ch
8 ohms 1 kHz, THD 0.7%
110 W + 110 W, 120 W/ch
8 ohms 1 kHz, THD 10%
125 W + 125 W, 150 W/ch |
| ||
Models of area code CEL, CEK, E2, TW, AU |
| ||
Stereo Power Output1), Reference Power |
| ||
| |||
Output1)2) |
| ||
| |||
8 ohms 20 Hz – 20 kHz, THD 0.09% | Additional | ||
85 W + 85 W, 110 W/ch | |||
| |||
8 ohms 1 kHz, THD 0.7% |
| ||
100 W + 100 W, 120 W/ch |
| ||
8 ohms 1 kHz, THD 10% | Information | ||
Stereo Power Output1), Reference Power | |||
125 W + 125 W, 150 W/ch |
| ||
Models of area code SP |
| ||
Output1)2) |
| ||
8 ohms 20 Hz – 20 kHz, THD 0.09% |
| ||
70 W + 70 W, 90 W/ch |
| ||
8 ohms 1 kHz, THD 0.7% |
| ||
80 W + 80 W, 100 W/ch |
| ||
8 ohms 1 kHz, THD 10% |
| ||
100 W + 100 W, 125 W/ch |
| ||
continued |
|
| |
|
| ||
71GB