You can record from a video component using the receiver. See the operating instructions supplied with your recording component.
1 Press one of the input buttons to select the playback component.
You can also use INPUT SELECTOR on the receiver.
2 Prepare the playback component for playing.
For example, insert the video tape you want to copy into the VCR.
3 Prepare the recording component.
Insert a blank video tape, etc. into the recording component (VIDEO 1) for recording.
4 Start recording on the recording component, then start playback on the playback component.
Notes
•Some sources contain copy guards to prevent recording. In this case, you may not be able to record from the source.
•The audio signals input to the MULTI CH IN jacks are not output from the analog AUDIO OUT jacks even when MULTI CH IN is selected. The analog audio signals of the current or previously used input are output.
Using the Remote
Changing button assignments
You can change the factory settings of the input buttons to suit the components in your system. For example, if you connect a DVD recorder to the VIDEO 1 jacks on the receiver, you can set the VIDEO 1 button on this remote to control the DVD recorder.
1 Hold down the input button of which you want to change the assignment.Example: Press VIDEO 1.
2 Referring to the table below, press the corresponding button for the category you want.
Example: Press 4.
Now you can use the VIDEO 1 button to control the DVD recorder.
64GB