5:Preparing the receiver and the remote
Setting the voltage selectorIf your receiver has a voltage selector on the rear panel, check that the voltage selector is set to the local power supply voltage. If not, use a screwdriver to set the selector to the correct position before connecting the AC power cord to a wall outlet.
VOLTAGE
SELECTOR
120V
220V
240V
Connecting the AC power cordConnect the AC power cord to a wall outlet.
AC power cord
CENTER
+–
SURROUND BACK |
| |
L |
|
|
| R | L |
+ | – |
|
R | R | L |
FRONT A | ||
| FRONT B |
SPEAKERS
To the wall outlet
Note
Install this system so that the power cord can be unplugged from the wall socket immediately in the event of trouble.
Before using the receiver for the first time, initialize the receiver by performing the following procedure. This procedure can also be used to return settings you have made to their factory defaults.
Be sure to use the buttons on the receiver for this operation.
1,2
?/1
MASTER VOLUME
|
|
| MULTI CHANNEL DECODING |
|
|
|
|
| |
|
|
|
|
|
|
| DISPLAY | INPUT MODE |
|
|
|
|
|
|
|
| INPUT SELECTOR |
| |
SPEAKERS |
|
|
|
|
|
|
|
|
|
(OFF/A/B /A+B) |
|
|
|
|
|
|
|
|
|
AUTO CAL MIC |
|
|
|
|
|
|
|
|
|
| MEMORY/ | TUNING |
|
|
|
|
| MULTI CH IN | DIRECT |
| ENTER | MODE | TUNING | 2CH | A.F.D. | MOVIE | MUSIC | ||
VIDEO 3 IN/PORTABLE AV IN |
|
|
|
|
|
|
|
| |
PHONES |
|
|
|
|
|
|
|
|
|
VIDEO | L AUDIO R |
|
|
|
|
|
|
|
|
3
1 Press ?/1 to turn off the receiver.2 Hold down ?/1 for 5 seconds.“PUSH” and “ENTER” appears on the display alternately.
3 Press MEMORY/ENTER.After “CLEARING” appears on the display for a while, “CLEARED” appears.
The following items are reset to their factory settings.
•All settings in the LEVEL, TONE, SUR, TUNER, AUDIO, VIDEO and SYSTEM menus.
•The sound field memorized for each input and preset station.
•All sound field parameters.
•All preset stations.
•All index names for inputs and preset stations.
•MASTER VOLUME is set to “VOL MIN”.
•Input is set to “DVD”.
25GB
Started Getting