Inputs |
|
Analog | Sensitivity: 500 mV/ |
| 50 kohms |
| S/N3): 96 dB |
| (A, 500 mV4)) |
Digital (Coaxial) | Impedance: 75 ohms |
| S/N: 100 dB |
| (A, 20 kHz LPF) |
Digital (Optical) | S/N: 100 dB |
| (A, 20 kHz LPF) |
Outputs (Analog) |
|
AUDIO OUT | Voltage: 500 mV/10 |
| kohms |
SUB WOOFER | Voltage: 2 V/1 kohm |
Tone |
|
Gain levels | ±6 dB, 1 dB step |
3)INPUT SHORT (with sound field and tone bypassed).
4)Weighted network, input level.
FM tuner section
Tuning range | 87.5 - 108.0 MHz |
Antenna | FM wire antenna |
Antenna terminals | 75 ohms, unbalanced |
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
Area code | Tuning scale | |
| 10 kHz step | 9 kHz step |
|
|
|
U, CA | 530 – | 531 – |
| 1,710 kHz5) | 1,710 kHz5) |
Antenna | Loop antenna |
|
Intermediate frequency |
| |
| 450 kHz |
|
5)You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. While holding down TUNING MODE, press ?/1. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure.
Video section
Inputs/Outputs
Video:1
COMPONENT VIDEO:
Y: 1
PB/CB: 0.7
PR/CR: 0.7
General
Power requirements
Area code | Power requirements |
U, CA | 120 V AC, 60 Hz |
| |
Power output (DIGITAL MEDIA PORT) | |
DC OUT: | 5 V, 0.7 A MAX |
Power consumption |
|
|
|
Area code | Power consumption |
|
|
U | 220 W |
|
|
CA | 300 VA |
|
|
Power consumption (during standby mode)
0.3W
Dimensions (w/h/d) (Approx.)
| 430 × 157.5 × 318 mm |
| (16 7/8 × 6 2/8 × 12 5/8 |
| inches) including |
| projecting parts and |
| controls |
Mass (Approx.) | 7.7 kg (16 lb 16 oz) |
Supplied accessories
Operating Instruction (this manual) Quick Setup Guide (1)
FM wire antenna (aerial) (1) AM loop antenna (aerial) (1)
Remote commander
For details on the area code of the component you are using, see page 3.
Design and specifications are subject to change without notice.
62US