Changing the factory setting of an input selector button (continued)
2 Press the corresponding button of the component you want to assign to the input selector button (for example,
1 – CD player).
The following buttons are assigned to select the input source:
To operate | Press |
CD player | 1 |
|
|
VCR (command mode VTR 2*) | 2 |
|
|
VCR (command mode VTR 3*) | 3 |
|
|
DVD player | 4 |
|
|
TV | 5 |
|
|
DSS (Digital Satellite Receiver) | 6 |
|
|
Tuner (this receiver) | 7 |
|
|
DCS (Digital CS Tuner) | 8 |
|
|
BSD (Digital BS Tuner) | 9 |
|
|
Tuner (Component tuner) | 0/10 |
|
|
*Sony VCRs are operated with a VTR 2 or 3 setting. These correspond to 8mm and VHS respectively.
Now you can use the DVD button to control the CD player.
To reset a button to its factory setting
Repeat the above procedure.
To reset all the input selector buttons to their factory setting
Press ?/1, AV ?/1and MASTER VOL – at the same time.
Additional Information
Precautions
On safety
Should any solid object or liquid fall into the cabinet, unplug the receiver and have it checked by qualified personnel before operating it any further.
On power sources
•Before operating the unit, check that the operating voltage is identical with your local power supply. The operating voltage is indicated on the nameplate at the rear of the receiver.
•The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the receiver itself has been turned off.
•If you are not going to use the receiver for a long time, be sure to disconnect the receiver from the wall outlet. To disconnect the AC power cord, grasp the plug itself; never pull the cord.
•AC power cord must be changed only at the qualified service shop.
On heat buildup
Although the unit heats up during operation, this is not a malfunction. If you continuously use this unit at a large volume, the cabinet temperature of the top, side and bottom rises considerably. To avoid burning yourself, do not touch the cabinet.
On placement
•Place the receiver in a location with adequate ventilation to prevent heat buildup and prolong the life of the receiver.
•Do not place the receiver near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock.
•Do not place anything on top of the cabinet that might block the ventilation holes and cause malfunctions.
•Use caution when placing the unit on surfaces that have been specially treated (with wax, oil, polish, etc.) as staining or discoloraion of the surface may result.
On operation
Before connecting other components, be sure to turn off and unplug the receiver.