Receiving Broadcasts
Before receiving broadcasts, make sure you have connected FM and AM antennas to the receiver (see page 6).
Manual memory
You can enter a frequency of the station you want directly by using the cursor buttons, and preset the stations to the receiver.
1 Press TUNER FM/AM to select the FM or AM band.
2 Press MEMORY/ENTER.
The receiver enters the Manual Memory mode.
The current frequency appears and the preset number flashes in the display. Do steps 3 to 5 before “PUSH” and “ENTER” flashes in the display.
3 Press +/– to tune in a station.
If “PUSH” and “ENTER” flashes before you tune in a station, start again from step 2.
4 Press the cursor buttons (U or u) to select a preset number.
If “PUSH” and “ENTER” flashes before you select the preset number, start again from step 2.
5 Press MEMORY/ENTER.
6 Repeat steps 2 to 5 to preset another station.
Tip
When the FM station is tuned in, you can press TUNER to switch the MONO mode to STEREO mode manually.
Automatic memory
If you don’t know the frequency of the station you want, you can let the receiver scan all available stations in your area and preset the stations to the receiver.
Press and hold MEMORY/ENTER, then press ?/1.
“AUTO MEMORY START” appears in the display.
The receiver scans from low to high frequencies of FM stations, then repeat scanning of AM stations.
When a station is tuned in, the station is automatically stored in the memory in the following order.
tA1tA2t...tA0tB1tB2t...tB0
C0T...C2TC1T
If all preset channels are memorized before scanning all stations, scanning stops and “MEM. FULL” appears in the display.
To cancel
Press ?/1during any step.
24