Press TUNER.

Tuning to preset stations

Automatic tuning

After preseting radio stations, you can tune in any of them directly by entering its

2-character preset code using the supplied remote. Up to 30 FM or AM stations can be preset. The receiver will also scan all the stations that you have preset.

You can tune the preset stations by either of the following two ways.

Scanning the preset stations

1

2 Press the cursor buttons (U or u) repeatedly to select the preset station you want.

Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:

tA1yA2y...yA0yB1yB2y...yB0T

tC0y...C2yC1T

Using the preset codes

Use the supplied remote to perform the following operations. For details on the buttons used in this section, see pages 33–34.

1 Press TUNER.

The last received station is tuned in.

2 Press SHIFT to select a memory page (A, B, or C), then press the preset number of the station you want using the numeric buttons.

If you don’t know the frequency of the station you want, you can let the receiver scan all available stations in your area.

1 Press TUNER FM/AM to select the FM or AM band.

The last received station is tuned in.

2 Press + or –.

Press + to scan from low to high; press – to scan from high to low.

The receiver stops scanning whenever a station is received.

When the receiver reaches either end of the band

Scanning is repeated in the same direction.

3 To continue scanning, press + or – again.

Tips

•If you press + or – during Automatic Tuning, Automatic Tuning stops.

•If you press + or – within a second after the Automatic Tuning stops, the frequency changes by a single step.

Direct tuning

You can enter a frequency of the station you want directly by using the numeric buttons on the supplied remote.

1 Press TUNER on the remote.

2 Press FM/AM to select the FM or AM band.

3 Press D.TUNING.

4 Press the numeric buttons to enter the frequency.

If you cannot tune in a station and the entered numbers flash

Make sure you’ve entered the right frequency. If not, repeat steps 3 and 4. If the entered numbers still flash, the frequency is not used in your area.

Broadcasts Receiving

25