Receiver Operations
Presetting Radio Stations
You’ll most likely want to preset the receiver with the radio stations you listen to often so that you don’t have to tune in the station every time. The receiver can store a total of 30 FM or AM stations. You can store the stations on preset numbers combining 3 characters (A, B, C) and numbers (0 - 9). For example, you can store a station as preset number A1, B6 or C9, etc.
Numeric PRESET
DISPLAY buttons TUNING +/– NAME
SHIFT MEMORY TUNER +/– ENTER
1Press TUNER.
The last received station is tuned in.
2Tune in the station you want.
If you are not familiar with how to tune in a station, see “Receiving Broadcasts” on the previous page.
3Press MEMORY.
“MEMORY” appears for a few seconds.
Do steps 4 and 5 before “MEMORY” goes out.
4Press SHIFT to select a character (A, B or C). Each time you press SHIFT, the letter “A,” “B” or “C” appears in the display.
If “MEMORY” disappears, start again from step 3.
5While MEMORY is displayed, press the number you want to use (0 to 9).
6Repeat Steps 2 to 5 to preset other stations.
To change a preset station
Preset a new station on the number you want to change.
Note
If the mains lead is disconnected for about one week, the preset stations will be cleared from the receiver’s memory, and you will have to preset the stations again.
Tuning preset stations (preset tuning)
You can tune directly to a preset station by entering its preset number. If you don’t know which stations are preset on which numbers, you can tune by scanning the preset stations.
1Press TUNER.
The last received station is tuned in.
2Press SHIFT to select a character (A, B or C), then press the number.
For example, select A and then press 7 to tune in the station preset as A7.
You can tune by scanning the preset stations
First press TUNER and then press PRESET TUNING + or – to select the station you want. Each time you press the buttons, the preset numbers change as follows:
nA1 ˜A2 ˜… ˜A0 ˜B1 ˜B2 ˜… ˜B0 N nC0 ˜… ˜C2 ˜C1N
Naming preset stations
You can store names, up to 8 characters long, for your preset stations. Once you name a preset station, the name appears in the display instead of the frequency when you tune to that preset.
The characters you can use include letters, numbers and symbols.
1Tune to the preset station you want to name.
2Press NAME.
The cursor blinks in the display.
3Use + or – to select the character you desire.
4Press NAME to move the cursor into position for the next character.
5Repeat steps 3 and 4 to enter up to 8 characters.
6Press ENTER to store the names.
If you make a mistake
Press NAME repeatedly so that the character you want to change blinks in the display, then use + or – to select the desired character.
To display index names
Press DISPLAY repeatedly to display index names and program source (or frequency if you select TUNER).
Notes
•You can also enter a name of up to 8 characters for programme sources. Select the programme sources you want and repeat steps 2 to 6.
•To clear programme source name, press NAME and then press the same programme source button. Press ENTER to delete the name (except TUNER).