Receiver Operations
Recording
This receiver makes it easy to record to and from the components connected to the receiver. You don’t have to connect playback and recording components directly: once you select a programme source on the receiver, you can record and edit as you normally would using the controls on each component.
Before you begin, make sure you’ve connected all components properly.
Function buttons
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
| Playback component |
| Recording component | |||||||||
| (programme source) |
| (MD deck, | |||||||||
|
|
|
|
|
|
| Tape deck, VCR) | |||||
ç: Audio signal flow | ||||||||||||
|
|
|
|
| ||||||||
|
|
|
|
| ||||||||
c: Video signal flow |
|
|
|
|
| |||||||
Recording on a MiniDisc or audio tape
You can record on a MiniDisc or cassette tape using the receiver. See the instruction manual of your MD recorder or tape deck if you need help.
1Press one of the function buttons to select the programme source.
2Set the component to be ready for playing. For example, insert a CD into the CD player.
3Insert a blank disc or tape into the recording deck and adjust the recording level, if necessary.
4Start recording on the recording deck and then start playing the component.
Recording on a video tape
You can record from a TV or a LD player using the receiver. You can also add audio from a variety of audio sources when editing a video tape. See your VCR’s instruction manual if you need help.
1Press TV/LD to select the programme source.
2Set the component to be ready for playing. For example, turn on the TV and TV tuner.
3Insert a blank video tape into the VCR for recording.
4Start recording on the VCR.
You can replace audio while editing a video tape
At the point you want to start adding different sound, press another function button (for example, CD) and start playback. The sound from the selected component will be recorded over the original audio.
To resume recording the original sound, press the TV/LD function button.
Note
You cannot record the audio and video signal during 5.1 CH/DVD mode.
Using the Sleep Timer 
You can set the amplifier to turn off automatically at a time you specify.
SLEEP
Press SLEEP on the remote while the power is on. Each time you press SLEEP, the time changes as shown below.
n2:00:00 n1:30:00 n1:00:00 n0:30:00 nOFF
The display dims after you specify the time.
You can check the time remaining before the amplifier turns off
Press SLEEP on the remote. The remaining time appears in the display.