Hooking Up the Components

This chapter describes how to connect various audio and video components to the receiver. Be sure to read the sections for the components you have before you actually connect them to the receiver.

Unpacking

Check that you received the following items with the unit:

•FM wire antenna (1)

•AM loop antenna (1)

•Remote commander RM-TP504 (remote) (1)

•LR6 (size-AA) alkaline batteries (4)

•Coin shaped lithium battery (CR-2032) (1) Models of area code UC only

•Audio/video/control S connecting cord (1)

•Control S connecting cord (1)

•Remote commander RM-US104 (remote) (1)

•R6 (size-AA) batteries (2)

Inserting batteries into the remote

Insert batteries with the + and – properly oriented in the battery compartment. When using the remote, point it at

the remote sensor on the receiver.

For details, refer to the operating instructions supplied with your remote.

zWhen to replace batteries

Under normal conditions, the batteries should last for about 3 months. When the remote no longer operates the receiver, replace all batteries with new ones.

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use a new battery with an old one.

•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•If you don’t use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

•The remote RM-TP504 is designed for use with alkaline batteries only. Do not use a combination of different battery types.

Before you get started

•Turn off the power to all components before making any connections.

•Do not connect the AC power cord until all of the connections are completed.

•Be sure to make connections firmly to avoid hum and noise.

•When connecting an audio/video cord, be sure to match the color-coded pins to the appropriate jacks on the components: yellow (video) to yellow; white (left, audio) to white; and red (right, audio) to red.

4