Broadcasts Receiving

Preset Tuning

For details on the buttons used in this section, see “Brief descriptions of buttons used to receive broadcasts” on page 46.

Before tuning to preset stations, be sure to preset them by performing steps on “Presetting radio stations” below.

Presetting radio stations

1Rotate FUNCTION to select the tuner.

The last received station is tuned in.

2Tune in the station that you want to preset using Direct Tuning (page 47) or Automatic Tuning (page 47).

3Press MEMORY.

“MEMORY” appears in the display for a few seconds. Do Steps 4 and 5 before “MEMORY” goes out.

4Press PRESET TUNING + or PRESET TUNING – to select a preset number.

If “MEMORY” goes out before you press the preset number, start again from Step 3.

5Press MEMORY again to store the station.

If “MEMORY” goes out before you press the preset number, start again from Step 3.

6Repeat Steps 2 to 5 to preset another station.

To change a preset number to another station

Do Steps 1 to 6 to preset the new station to the number.

Note

If the AC power cord is disconnected for about two weeks, all the preset stations will be cleared from the receiver’s memory, and you will have to preset the stations again.

Tuning to preset stations

You can tune the preset stations either of the following two ways.

Scanning the preset stations

1Rotate FUNCTION to select the tuner.

The last received station is tuned in.

2Press PRESET TUNING + or PRESET TUNING – repeatedly to select the preset station you want.

Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:

nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N￿

nC0˜...C2˜C1N

Using the preset codes

Use the supplied remote to perform the following operations. For details on the buttons used in this section, see the operating instructions for the supplied remote.

1Rotate FUNCTION to select the tuner.

The last received station is tuned in.

2For remotes without a display:

Press SHIFT to select a memory pare (A, B, or C), then press the preset number of the station you want using the numeric buttons on the supplied remote.

For remotes with a display:

Select the preset station you want from the list displayed on the supplied remote when TUNER is selected.

48