Installation Instructions
STEP 7 INSTALL FILTERS
•Drop grease tray into the hood. The rear tabs should engage the slots in the hood track.
•Insert the filter into the opening and drop into the bottom. Raise filter to the top and lock into place.
•To remove the filters, grasp the latch, pull the filter up and lift out.
STEP 8 INSTALL BACKGUARD AND SHELF This hood can be installed with the
warming shelf and backguard together or with the warming shelf or backguard alone.
INSTALL BACKGUARD:
•Remove packaging.
•Place backguard against the bottom of the hood to use as a template. Mark upper screw locations “A” and “B”
•Remove backguard.
•Drill four 1/8" pilot holes at screw locations “A” and “B”.
•If drill did not enter studs, enlarge holes to 3/8".
•Insert wall anchors into the enlarged holes. Remove screws from wall anchors.
•Align and secure backguard to wall using 2 wall anchor screws or wood screws in locations “A”.
•For 30" and 36" models, install 2 screws through hole locations “C” at the bottom of the backguard. For 48" models, install 4 screws.
INSTALL SHELF OVER BACKGUARD:
•Install two shoulder screws into holes “D” in the bottom of hood flange leaving 1/8" gap.
•Remove shelf packaging and protective film.
•Engage shoulder screws into the keyhole slots in the top of the shelf. Slide shelf towards the left to lock into place.
•Install two 3/4" long machine screws through the bottom of the shelf into the bottom hood flange, location “E”.
•Install anchor screws through the shelf and into the wall holes “B”.
•Remove all protective film.
|
| A |
Mounting | A | B |
| ||
B |
| |
Holes for |
| |
Backguard (A, C) |
|
|
and Shelf (B) |
|
|
C
•If installing the backguard alone, without the shelf, drive screws in all locations shown.
D
E 
B
1/8"
Gap
E
D B
14
