GE ZV30R, ZV36R, ZV48R Connect Ductwork, Install Duct Covers, Install Motor

Duct Tape Over Transition

STEP 4 CONNECT ELECTRICAL

Verify that power is turned off at the source.

WARNING: If house wiring is not

2-wire with a ground wire, a ground must be provided by the installer. When house wiring is aluminum, be sure to use U.L. approved anti-oxidant compound and aluminum-to-copper connectors.

AVERTISSEMENT – Si le câblage

de la maison n’est pas du type à deux fils avec un fil de terre, l’installateur doit fournir un circuit de terre. Quand les fils de la maison sont en aluminium, il prendre soin d’utiliser de la pâte antioxidation approuvée par UL et des connecteurs pour l’aluminium-cuivre.

Duct Tape

Over Seam

and Screw

Installation Instructions

STEP 3	CONNECT DUCTWORK		STEP 5	INSTALL DUCT COVERS
• Install ductwork, making connections in direction of			Note: For easier handling, remove cardboard insert
airflow as illustrated.
			after film is peeled off.
• Secure joints in ductwork with sheetmetal screws.
• Wrap all duct joints with			Remove protective film from duct covers. If more than
duct tape for an airtight seal.			one duct cover is used, secure each piece together with
• Use duct tape to seal the			screws provided.
flange connection.		Air Flow	• Place the duct cover(s) on top of the hood.
Reach inside the			• From inside the hood, secure the duct cover to the
hood and push		Screw	top with the small Phillips head screws supplied with
the damper up			the covers.
to be sure it
moves freely.

A Remove	B Insert Power
Junction Box	Conduit Thru
Cover	Strain Relief
	and Tighten
	Ground
	C Use UL Listed
	Wire Nuts

White

Black

STEP 6 INSTALL MOTOR

	Outlet
Attachment	Spring
Slot	Clip

•From the inside of the hood, slip motor into the attachment slot on the left.

•Rotate motor upwards until it snaps into the spring clip on the right.

•Secure the motor to the hood with the machine screw and lock washer. (Screw is marked with red or blue paint.)

•Plug connector into the motor.

Attachment

Screw

Top

IMPORTANT: Connector ends	Spring
are designed to mate only	Clip
one way. Match flat and
round connectors as shown.

•Use wire nuts to connect incoming ground to green, white to white and black to black.

•Push wires into junction box and replace cover. Be sure wires are not pinched.

13