Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED) |
| 1/4" pivoting | Hammer | |||
|
|
|
| hex socket | ||
| Duct tape | Wire cutter/stripper |
| Key Hole Saw | Electric or battery operated drill | |
|
|
|
|
| and 1/8", 3/8" bits | |
|
|
|
|
|
| |
Pencil and tape measure |
|
|
|
| 10" round metal | |
|
|
|
|
|
| duct, length to |
|
| Safety glasses | Wire nuts |
| suit installation. | |
|
|
|
|
|
| |
Spirit level |
|
|
|
|
| Phillips and flat |
|
|
|
|
|
| blade |
|
|
|
| Flashlight |
| screwdrdivers |
|
|
|
|
|
| |
|
|
|
|
|
| Strain relief for |
| Step ladder |
|
|
| junction cover. | |
Pliers |
|
|
| 120V 60Hz. 15 or 20 Amp, | ||
Metal Snips | Saber saw |
| ||||
|
| |||||
or Sawsall | grounded branch circuit. |
|
REMOVE THE PACKAGING
•Remove packages from the “V” shaped cardboard section. Remove shipping pads.
•Lift the hood out of the box.
IMPORTANT: Lift the hood by grasping the outside edges of the exhaust opening on the top.
|
| Duct |
|
| Transition |
Wood |
|
|
Mounting | Hood | Parts |
Support |
| |
|
| |
| Motor |
|
| Mounted |
|
| on Skid |
|
Shipping Carton
•The vent hood motor is shipped secured to the skid with 4 screws. Locate and remove 2 screws on each side of the motor. Discard the shipping skid and screws.
•Grease filters must be removed. Grasp the latch, pull the filter up and lift out.
•Lift to remove the grease trays. Set grease filters and trays aside for later installation. DO NOT DISCARD.
•From the inside of the hood, loosen (do not remove) the 2 screws holding the wood mounting support to the back of the hood. The screws should be backed out of the wood to 1/4". Remove and set aside the mounting support with screws for later installation.
DO NOT DISCARD.
•Remove tape and packing material from the hood and all supplied parts.
8
