Adjustments using the
SET UP button
The SET UP button allows you to make the following adjustments.
1 Press SET UP.
2 Press the cursor buttons ( or ) to select the parameter you want to adjust.
3 Turn the jog dial to select the setting you want.
The setting is entered automatically.
4 Repeat steps 2 and 3 until you have set all of the parameters that follow.
Initial settings
Parameter | Initial setting |
6.1CH DECODING | AUTO |
|
|
MULTI CH 1 or 2 | NONE |
|
|
D.POWER | AUTO OFF |
|
|
V.POWER | AUTO OFF |
|
|
S.FIELD LINK | ON |
|
|
DECODE FORMAT | AUTO |
|
|
AUTO FUNCTION | ON |
|
|
2 WAY REMOTE | ON |
|
|
COMMAND MODE | AV1 |
|
|
T.TONE | NORMAL |
|
|
COLOR SYSTEM | PAL |
|
|
OSD | COLOR |
|
|
OSD H.POSITION | 4 |
|
|
OSD V.POSITION | 4 |
|
|
x6.1ch decoding mode (6.1CH
DECODING)
You can set this parameter using 6.1CH DECODING on the front panel (page 33).
•When set to “AUTO”, the receiver performs
6.1channel decoding only if 6.1 channel signals decode flag is ON.
•When set to “ON”, the receiver performs
6.1channel decoding only if the surround signals are multi channel format [3/2], [3/2+1] or [3/3] regardless of the 6.1 channel decode flag.
•When set to “OFF”, the receiver does not perform 6.1 channel decoding.
Tip
The 6.1 channel decoding flag is the information recorded on the software (DVD, etc).
xMulti channel assignment (MULTI CH 1 or 2)
Lets you assign a function to MULTI CH 1 or 2. You cannot assign TUNER or PHONO.
You cannot assign the same function to both MULTI CH 1 and 2.
50