Step 5:2 Connect the cables.
Safety measures to

Run the cables through the cable holders and the Rear

Pillar holes.

prevent toppling over

 

WARNING

Be sure to take measures to prevent the TV Stand from toppling over, and causing possible injury and damage.

1 Attach the support belt.

1Screw the support belt to the TV Stand with the supplied wood screw using the screwdriver.

2Attach the support belt to the Table-Top Stand, and screw the belt with the supplied securing screw using a coin, etc.

3Adjust the length by tightening the support belt while holding the Table-Top Stand.

Note

If the cables are not installed properly, they might be pinched and damaged, and could result in electric shock, etc.

3 Anchor the TV to the wall.

Prepare a strong, commercially-available rope or chain and wall anchor bracket for this purpose.

1Secure the wall anchor bracket to a solid wall.

2 Pass the rope or chain through both holes of the anchor bolts and then tighten the other end of the rope or chain to the wall anchor bracket.

Strong rope or chain

Wall anchor bracket

10 (GB)