Step 2:Assembling the TVStand

WARNING

If you allow the AC power cord to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock. If you stumble over the AC power cord or the connecting cable, the TV Stand may topple over and cause injury.

Decide on the installation location and lay the TV Stand down before installing the TV.

Since the TV is heavy, it is recommended that you decide on the installation location beforehand, and assemble the TV Stand on site.

2Attach the Rear Pillar to the Base Board and secure the two Cam-locks with a screwdriver.

Cam-lock*

Rear Pillar

1 Attach the Rear Pillar to the Base Board.

*Before attaching the Rear Pillar, make sure that the F mark points downward.

1 Tighten the two supplied Cam-lock screws to the

2 Attach the Side Pillars to the

Base Board.

Cam-lock screw

Base Board.

Secure the Side Pillars and the Base Board with the

 

 

four supplied screws (+PWH5 × 25).

 

Side Pillar (L)

Base Board

 

 

Side Pillar (R)

Arrow direction shows front of the TV Stand.

Screw (+PWH5 × 25)

Note

There are differences between the left and right pillars.

Be sure to install each pillar on the correct side.

6 (GB)