2 Adjust the angle of the stabilizer arms.

When installing the TV perpendicularly (0 degrees), adjustment of the arms angle (Procedure 1 and 2 below) is not necessary. Make sure that each stabilizer arm is screwed in securely.

1Remove the screws that are at the top and bottom center of the both stabilizer arms.

Then choose the notch corresponding to the desired angle (5,10,15 or 20 degrees) and fit the stabilizer arm to it.

2Firmly secure each stabilizer arm using the screws removed in Procedure 1.

Notes

•Be sure to adjust the angles of the right and left arms to the same angle.

•Be careful not to pinch your fingers when adjusting the angle of arms.

•When using an electric screwdriver, set the torque setting to approximately 2 N·m.

•0 degrees: Leave the white screws tightened as they are.

•Other than 0 degrees: Remove the white screws.

Stabilizer arm

1 2

Step 4: Prepare for the installation of the TV

1 Remove the screws that hold the TV to the Tabletop Stand.

Clamp screw

2 Detach the TV from the Tabletop Stand, and place the TV, with its screen facing down on a Stable, cloth-covered work surface, at least 20 cm (8 in.) off the floor.

Note

Be sure that two or more persons hold the TV when carrying it. Do not hold the transparent parts at either the top or bottom of the TV.

9 (US)