Frymaster 8196339 Corrective Action, Probable Causes, Error Messages and Display Problems, Probe

PROBLEM	PROBABLE CAUSES	CORRECTIVE ACTION
Heat indicator is on
and blower is	Blown fuse on interface board or	Replace fuse.
running, but burner	ignition module.
will not ignite.
7.2.2 Error Messages and Display Problems
		Corrective Action
Problem	Probable Causes
CM7 display is in
wrong temperature	Incorrect display option programmed.	See page 4-16 for instructions.
scale (Fahrenheit or
Celsius).		Verify that the drain valve is fully
CM 7 display shows	Open drain valve or problem with
IGNITION		closed. If the problem continues
FAILURE.	latching circuitry.	call your FASC.
		This in an indication of a
CM7 display shows	Frypot temperature is more than	malfunction in the temperature
		control circuitry, including a
	410ºF (210ºC) or, in CE countries,
hot-hi-1.		failure of the high-limit thermostat.
	395ºF (202ºC).	Shut the fryer down immediately
		and call your FASC.
CM 7 display shows	Fryer temp is above setpoint.	Ensure setpoint is set correctly. If
HIGH temp.		problem persists call your FASC.
		This display is normal when the
		fryer is first turned on and may
CM7 display shows		appear for a short while if a large
	Frypot temperature is between 180°F	batch of frozen product is added to
LOW TEMP.	(82°C) and 315°F (157°C).	the frypot. If the display never
		goes out, the fryer is not heating.
		Shut the fryer down and call your
		FASC.
CM7 display shows	Problem with the temperature	Shut the fryer down and call your
PROBE	measuring circuitry including the	FASC.
FAILURE.	probe.	Verify that the drain valves are
CM7 display shows	Open drain valve, failed computer,	fully closed. Using the ON/OFF
		switch, turn the computer OFF and
IGNITION	failed transformer, open high-limit
		then ON again. If this does not
FAILURE.	thermostat.
		correct the problem, call your
		FASC.
CM 7 display shows	Frypot temperature is more than	Call your FASC.
	410ºF (210ºC) or, in CE countries,
HOT-HI -1.
	395ºF (202ºC).

7-3