TrackSnap Manual | Model |
Auto Walk-Test mode on power up
When turning power on to your TrackSnap both the red and green LED will light up. They will both stay on for 30 seconds. This time will allow the PIR circuit to warm up. After this time expires the green LED will turn off and the red LED will blink 5 times letting you know that the board is entering a 1 minute automatic walk- test phase. At this point you can move around the camera setup and check out the PIR area. Both the green and red LED’s will light when motion is detected. After the 1 minute automatic
Adjusting the PIR Sensitivity POT
To adjust the PixController PIR detection range simply turn the single turn POT shown to the left to your desired range. The default setting is in the middle, as shown. The two “dots” on the Philips head screw show the actual location.
The default setting is desirable for almost all weather conditions. In very hot summer months, or setups over fields with no shading cover you should reduce the PIR sensitivity.
Note: Turning the sensitivity to the minimum setting will turn the PIR detection off.
Adjusting the Day/Night Cal. POT
When adjusting the Day/Night Sensor POT you must first set the DIP switches 3 & 4 “Up” when the board is powered down, and then turn the board on. The “Red Control LED” will light up when the detection level detects darkness. You may want to adjust this in the darkest setting you want to run your system at when adjusting this POT. When finished you will need to return DIP switches 3 & 4 back to their original setting.
Version | Page 4 of 12 | Released |
TS P41.2 | This document comprises information provided by Suppliers and is |
|
| assumed to be correct. |
|
